Wall Mounting - Siemens FDV241 Manuel De Mise En Service

Wall mounting

8 Wall mounting
18
Building Technologies
Fire Safety & Security Products
All manuals and user guides at all-guides.com
Overheating of the device
In case of overheating the device will shut down automatically.
LED 1 on the front of the device will be lit red.
IMPORTANT Check to ensure there is a minimum clearance of 10 cm to the ventilation
holes on the housing cover.
Measure the ambient temperature. See Section 4: Technical data.
When the device has cooled down sufficiently, it will boot up automatically.
Mounting the device to the top-hat rail
Screw the recommended top-hat rail to the wall.
1.
See Section 4: Technical data.
Risk of bodily injury or damage to the device/system due to incorrect
installation
If the device is not mounted correctly there is a risk that it will fall down.
CAUTION
1. Make sure that the device properly engages into the top-hat rail.
2. Secure the device against lateral displacement using rail stoppers on both
sides.
Hang the device in the top-hat rail from above.
2.
Flip the device down.
3.
Secure the device against lateral displacement using rail stoppers on both
4.
sides.
The device is now mounted.
Removing the device from the top-hat rail
Use a screwdriver to pull the tab in the middle of the bottom of the device
1.
down.
Remove the device.
2.
The device is now dismounted.
11.2008