Mounting And Installation - Siemens PolyCool CPS 40 Manuel D'installation Et D'utilisation

A Mounting on DIN rail
B Wall mounting
C Flush panel mounting
Recommendation!
Building Technologies
HVAC Products

3.1 Mounting and installation

Controller
No further parts are needed.
With four ellipse screws for holes with diameter of
4 mm x 6 mm
With HVAC Products ARG462.10 mounting kit
Mounting instruction M 3351.1
Electronic injection valve (EIV)
Laboratory measurements reveal that control
performance improves when the valve is installed higher
than the evaporator (min. 5 cm)! This is especially
important with plate heat exchangers.
CPS40 CE1U3372XX / H 74 319 0555 0 a
22.09.2006
29/124