Miller MIGMATIC 220 Manuel De L'utilisateur page 56

Table des Matières

Publicité

NOTE
Wire Diameter
Metric
0.6/0.8 mm*
0.023/0.030 in
0.8/1.0 mm*
0.030/0.035 in
1.0/1.2 mm*
0.035/0.045 in
0.8/1.0 mm**
0.035/0.045 in
1.2/1.6 mm**
0.045/0.065 in
1.0/1.2 mm*
0.035/0.045 in
* Available in: steel, 30 mm diameter
**Available in: nylon, 30 mm diameter
OM-246 691 Page 52
Table 7-1. Drive Roll And Wire Guide Kits (2 Roll Models)
Base selection of drive rolls upon the following recommended usages:
1. V-Grooved rolls for hard wire.
2. U-Grooved rolls for soft and soft shelled cored wires.
3. U-Cogged rolls for extremely soft shelled wires (usually hard surfacing types).
4. V-Knurled rolls for hard shelled cored wires.
5. Drive roll types may be mixed to suit particular requirements (example:
V-Knurled roll in combination with U-Grooved).
Fraction
Decimal
0.023/0.030 in
0.030/0.035 in
0.035/0.045 in
0.030/0.035 in
0.035/0.065 in
0.035/0.045 in
Drive Roll
Part No.
Type
156053051
V
156053109
V
156053052
V
156053053
U
156053054
U
1560531110
V-K
Wire Guide
Inlet
156090022

Publicité

Table des Matières
loading

Table des Matières