arjo Enterprise 5000X E5X Notice D'utilisation page 14

WARNING
If the power cord or mains plug is damaged, the complete assembly must be replaced
by authorised service personnel. Do not remove the fitted plug, or use a rewireable
plug or adapter.
Make sure the power supply cord is not stretched, kinked or crushed.
Do not allow the power supply cord to trail on the floor where it may cause a trip
hazard.
Make sure the power supply cord does not become entangled with moving parts of the
bed.
Disconnect the power supply cord from the electricity supply, and store it as shown,
before moving the bed.
CAUTION
Before the first use, or if the bed has been unused for more than three months, connect
the bed to the electricity supply for at least 24 hours to allow the backup battery to
recharge fully. Failure to do this may reduce the life of the battery.
The bed should be positioned with the roller buffers at least 20cm from the rear wall to
prevent the head board striking the wall when the bed is in head down tilt
(Trendelenburg).
Recommended positioning from rear wall
14