Hypertherm Powermax65 Mode D'emploi page 5

Remove the power supply cover, Mylar
1. Turn OFF the power, disconnect the power cord, and disconnect the gas supply.
2. Using a T15 TORX or blade screwdriver, remove the 8 small screws (2) from the power supply cover.
3. Using a T20 TORX or blade screwdriver, remove the 8 large screws (1) from the power supply cover.
4. Lift the cover (3) off the power supply.
5. Remove the Mylar barrier from the power-board side of the power supply. The Mylar barrier is flexible and can be
bent slightly for removal.
6. Remove the metal end panel bracket located on top of the center panel by pulling it straight up.
Field Service Bulletin
All manuals and user guides at all-guides.com
Powermax65/85 Power board rePlacement
1
2
2
1 1
barrier, and end panel bracket
®
1
2
3
2
1
3