Hypertherm Powermax65 Mode D'emploi page 16

Powermax65/85 Power board rePlacement
Replace the power supply cover
1. Place the cover (3) over the power supply with the slot in the cover (4) over the plastic tab in the front panel.
The slot and tab ensure that the vent in the side of the cover is over the fan. Be careful not to pinch any wires.
2. Using a T15 TORX or blade screwdriver, install the 8 small screws (2) into the power supply cover.
Tighten the screws to 15 in lbs (17.3 kg cm).
3. Using a T20 TORX or blade screwdriver, install the 8 large screws (1) into the power supply cover.
Tighten the screws to 15 in lbs (17.3 kg cm).
Front of
power supply
14
All manuals and user guides at all-guides.com
4
1
2
2
1 1
1
2
3
2
1
Field Service Bulletin