Light Emitting Diodes (Led) On Charger; Connecting The Water Supply - Stihl TSA 230 Notice D'emploi

Light Emitting Diodes (LED)
on Charger
1
The light emitting diode (1) on charger
glows continuously green or flashes red.
Green continuous light ...
... indicates the following:
The battery
is being charged
–
is too hot and must cool down
–
before charging
See also "Light Emitting Diodes (LEDs)
on Battery".
The green light emitting diode on the
charger turns off as soon as the battery
is fully charged.
TSA 230
Red flashing light ...
... indicates the following:
No electrical contact between
–
battery and charger – remove and
refit the battery
Malfunction in battery – see also
–
"Light Emitting Diodes (LEDs) on
Battery".
Malfunction in charger – have it
–
checked by a servicing dealer.
STIHL recommends a STIHL
servicing dealer.

Connecting the water supply

Only with wet cuts:
Connect the hose to the water
N
supply network
3
1
2
Push the coupling (1) on to the hose
N
connector (2)
when connected to the water supply
N
network, open the tap
before starting work, open the shut-
N
off valve (3) and allow water to flow
to the abrasive wheel
The water flow rate can be set via the
shut-off valve (3).
After finishing work:
Switch off the machine
N
Close the shut-off valve (3).
N
Disconnect the cut-off machine from
N
the water supply network
Water can also be supplied via the
pressurized water tank (special
accessory).
English
63