Checking The Motor Direction Of Rotation; Motor End Stop Setting; Memorising Remote Controls; Checking The Conformity Of The Installation - SOMFY Rollixo Smart io Manuel D'installation

EN
3.6

Checking the motor direction of rotation

NOTICE
If the product has already been set in the factory, go directly to the remote control programming stage.
> > > Illustration 10
1] Press and hold the "SET" button for 2 s.
ð The "POWER" indicator light flashes.
2] Press the "+" or "-" button to check the direction of rotation of the motor.
ð If the motor's direction of rotation is correct, move on to the Motor end stop setting [} p.34] step.
ð If the direction of rotation is incorrect, press the "+" and "-" buttons simultaneously until the mo-
tor performs and up-down movement. The "POWER" indicator will light up continuously for 2
seconds.
ð Check the motor's direction of rotation again then move on to the Motor end stop setting [} p.34]
step.
3.7

Motor end stop setting

> > > Illustration 11
1] Check that the motor is disengaged: the two push-buttons should be depressed.
2] Press the "+" button to move the garage door to the upper position. Adjust the upper position using
the "+" and "-" buttons.
3] Press the motor's upper end limit push-button.
4] Press the "-" button to move the garage door to the lower position. Adjust the lower position using
the "+" and "-" button.
5] Press the motor's low end limit push-button.
6] Press the "SET" button for 2 seconds to exit setting mode.
3.8

Memorising remote controls

> > > Illustration 12
NOTICE
If this procedure is carried out using a button which has already been memorised, the button will be cleared.
1] Press the "PROG" button for 2 s.
ð The "PROG" indicator light is permanently lit.
2] Press the outer left- and right-hand buttons on the remote control simultaneously until the indicator
light flashes.
3] Press the button selected to control the function (complete opening, Aux 230 V output control).
ð The "PROG" indicator light flashes for 5 s.
è The remote control has been memorised.
3.9

Checking the conformity of the installation

WARNING
Once installation is complete, it is essential to check that the obstacle detection system complies with An-
nex A of the standard EN 12453.
34
©
Copyright 2020 SOMFY ACTIVITES SA. All rights reserved.
Rollixo Smart io