Advanced Parameter Setting; Using The Programming Interface - SOMFY Rollixo Smart io Manuel D'installation

EN
Meaning of the different parameters [} p.39]
Lighting output power:
• either 5 fluocompact or LED lights
• or 2 power supplies for low-voltage LEDs
• or 1 halogen light, max. 500 W
5.2.5 Video entry phone
> > > Illustration 19
5.2.6 Antenna
> > > Illustration 20
6

ADVANCED PARAMETER SETTING

6.1

Using the programming interface

> > > Illustration 21
1] Press the "SET" button for 0.5 s to enter parameter setting mode.
ð Indicator light P0 flashes once.
2] Press the "+" or "-" button to change the value of the parameter.
ð The indicator light flashes x times to indicate the value selected.
3] Press the "SET" button for 0.5 s to confirm this value and move on to the next parameter.
ð If parameter P3 is selected, pressing the "SET" button for 0.5 s will cause you to exit parameter
setting mode.
4] Press the "SET" button for 2 s to confirm a value and exit parameter setting mode.
ð The integrated lighting and parameter setting indicator lights go out.
38
©
Copyright 2020 SOMFY ACTIVITES SA. All rights reserved.
Rollixo Smart io