Malfunctions - HSM 450.2 Notice D'utilisation

10. Malfunctions

If the paper shredder does not work properly, please check the following points before contacting our
customer service:
– Are voltage and frequency according to the data
on the name plate?
– Is mains plug inserted?
– Is main switch switched on?
– Are all electrical fuses in order?
– Is the front door closed?
– Is cut material bag full?
– Is there a paper jam in the shredder?
– Is the motor overloaded?
Paper jam (too much paper fed)
Red LED on membrane keyboard lights
• Motor reverses automatically and stops again after a few seconds.
Caution!
Injuries by cutting rollers are possible even when the paper shredder is idle.
Keep hands away from the cutting system when running!
Always wear protective gloves.
• Open the funnel flap and clear the paper jam.
If material is not completely pushed out, then
• Close the funnel flap again
• Press the reversing arrow button
• Remove the paper from the funnel flap
• Press the green arrow button
• Separate paper stack and feed paper again
Caution!
Do not press the pushbuttons "Forwards - Backwards" alternately to clear paper jam.
This will damage the paper shredder.
Electric motor overloaded
Red LED on membrane keyboard lights
• motor stops automatically
• allow motor to cool down approx. 15 - 20 min.
• Press the green arrow button
05/02
All manuals and user guides at all-guides.com
Paper shredder
GB
control data
insert mains plug
switch it on
control fuses
close
change bag
clear paper jam
allow motor to cool down for approx.
15–20 min.
HSM 450.2
19