Factory Default Settings; Technical Support - Emerson Numatics G2-2 Serie Guide De Démarrage Rapide

16) Factory Default Settings

Unless otherwise requested, all standard G2-2 Series Ethernet manifolds ship with specific factory default
settings. Below is a list of the factory default settings:
DHCP/BOOTP
Input Module Power Jumper
Output Module Power Jumper
Valve Side Output Bytes
Discrete I/O Side - I/O Bytes Self-Configuring based on the I/O modules installed.

17) Technical Support

For technical support, contact your local Numatics distributor. If further information is required,
please call Numatics Inc. at (248) 887-4111 and ask for Technical Support.
Issues relating to network set-up, PLC programming, sequencing, software related functions, etc...
should be handled with the appropriate product vendor.
Information on device files, technical manuals, local distributors, and other Numatics, Inc. products
and support issues can be found on the Numatics, Inc's. WEB site at
For general help or more information regarding Industrial Ethernet protocol, please see the following
appropriate web pages:
ODVA - www.odva.org
The following is a trademark used under license by ODVA: EtherNet/IP
G2-2 Series EtherNet/IP
Description
IP address DHCP/ BOOTP Enabled (192.168.3.120 in FLASH)
MAC Address
Baud Rate
3835056 TDG22ENQS2-0
Subject to change without notice
www.numatics.com/fieldbus
Quick Start Manual
Default Settings
A unique alpha-numeric code for each node
(00-30-11-XX-XX-XX).
Located on the cover of the EtherNet/IP
(Not user configurable)
10/100 Mbit per sec. (Autobaud)
Enabled
PU
(Input sensor power supplied by
+24VDC Node and Inputs pin on the Aux. power connector)
SP
(Output module power supplied by
+24VDC Valves and Outputs pin on the Aux. power connector)
4 Bytes (32 Allocated Valve Coil Outputs)
1/07
TM
and Modbus TCP
node.
™
www.numatics.com
™
Page 20