Emerson Numatics G2-2 Serie Guide De Démarrage Rapide page 17

Web Page Configuration
C.)
The Numatics G2-2 Ethernet node has an imbedded web server. This server can be accessed via any standard
web browser program. If the IP address of the node is known, the "Node Configuration Page" for the node
can be called up and the configuration parameters updated. If the IP address of the node is not known, it can
be set using any of the previously described methods. Please note that the PC, where the web browser is
installed, must be correctly configured for operation with the appropriate network IP ranges and Subnet
settings that match the G2-2 Ethernet node.
network settings and always record previous settings before attempting changes!
Below is a representation of the "Node Configuration Page" which is stored in the Ethernet node.
IP address, Subnet Mask, Gateway Address, SMTP server address and DHCP/BootP enabled selections can all be configured
from this page. These parameters will be programmed in the node's non-volatile FLASH memory once
"UPDATE CONFIG." is clicked.
Configuration Page
Modifications to the
take effect.
G2-2 Series EtherNet/IP
Quick Start Manual
Consult appropriate personnel before changing your computer's
settings require power to be cycled before changes
G2-2 Series EtherNet 10/100 Mbit/s
Node Configuration Page
IP Address:
Subnet Mask:
Gateway Address:
SMTP server:
DHCP/BOOTP enabled:
UPDATE CONFIG
3835056 TDG22ENQS2-0
Subject to change without notice
www.numatics.com/fieldbus
TM
and Modbus TCP
192.168.3.120
255.255.255.0
0.0.0.0.
0.0.0.0.
1/07
Page 17