Emerson Numatics G2-2 Serie Guide De Démarrage Rapide page 3

4) MCM - Manual Configuration Module (Optional)
Rotary Switch
(SW4)
The MCM is the module that allows the user to manually enable user definable options such as self test mode,
bit mapping offset (Modbus TCP ONLY) and byte swapping (Modbus TCP ONLY), without the need for
software configuration.
consists of two DIP switch sets (SW1 and SW2) and two rotary switches (SW3 and SW4).
MCM Module Part Numbers
G2-2 Series EtherNet/IP
DIP Switch
Rotary Switch
(SW2)
(SW3)
1 2 3 4 5 6 7 8
All DIP switches shown in the "OFF" position
If software configuration is preferred, this module is not
Description
Complete Module
Replacement Board
3835056 TDG22ENQS2-0
Subject to change without notice
www.numatics.com/fieldbus
TM
Quick Start Manual
DIP Switch
(SW1)
1 2 3 4 5 6 7 8
Part Number
1/07
and Modbus TCP
necessary. The MCM
239-1384
256-684
Page 3