Set Point - S&P CTB ECOWATT PLUS Manuel D'utilisation

SENSOR
< INTERNAL OK
OK OK
RANGE
< 400Pa OK
OK OK

SET POINT

< INTERNAL OK
OK OK
SET POINT CONSOLE
< 1300m3/h OK
OK OK
PARAMETERS
< Kq=133 OK
OK OK
SENSOR
<IN1 0-10V OK
SENSOR
<IN2 0-10V OK
Sensor: Sensor type
- INTERNAL: Pressure differential internal sensor
- IN1 0-10V: External sensor with analog signal 0-10V (J5 terminal)
- IN1 4-20mA: External sensor with analog signal 4-20mA (J5 terminal)
- IN2 0-10V: External sensor with analog signal 0-10V (J6 terminal)
- IN2 4-20mA: External sensor with analog signal 4-20mA (J6 terminal)
Press or to manually modify the parameter.
The value displayed corresponds to the scale of the
internal sensor factory pre-set. In an external sensor is
installed, introduce the corresponding range.
SET POINT
<CONSOLE OK
SET POINT
<IN1 4-20mA OK
SET POINT
<IN2 4-20mA OK
Set Point:
- INTERNAL: Factory set value
- CONSOLE: Value set by PROSYS ECOWATT console
- IN1/IN2 0-10V: Value set by external potentiometer (0-10V)
- IN1/IN2 4-20mA: Value set by external potentiometer (4-20mA)
Press or to manually modify the set point
parameter. This will appear if "
selected in "
SET POINT
Press or to manually modify this parameter.
It is advised not to modify.
SENSOR
<IN1 4-20mA OK
SENSOR
<IN2 4-20mA OK
SET POINT
<IN1 0-10V OK
SET POINT
<IN2 0-10V OK
" has been
CONSOLE
" menu.
49