Safety Information - Fluval SEA PS1 Mode D'emploi

SAFETY INFORMATION

ATTENTION: please verify that all components of the skimmer are undamaged before putting it into function. ALWAYS disconnect
electrical supply of the skimmer and any other appliance placed in the water before performing any maintenance. Be sure that the
voltage of the mains supply corresponds to the voltage shown on the unit's label.
DO NOT RUN DRY - Do not connect to electrical supply if pump is not completely immersed in water.
INSTALLATION
The Fluval Sea Protein Skimmer is designed to be positioned inside
an aquarium or sump filter by using the suction cups (A) or the mounting bracket (B).
In Aquarium
Choose where to position the skimmer inside your aquarium. Remember to clean
the aquarium surface carefully so the suction cups will adhere to the glass properly.
When using the mounting bracket, the suction cups can be removed from the
suction cup pins.
minimum/maximum water levels to guarantee adequate surface aspiration (C).
In Sump
If the sump does not not offer a min. 25.4 cm (10 inch) water level a suitable glass or plastic box may be placed in the sump that does.
The skimmer may be mounted within this box with water supplied by either a dedicated small submersible pump or the incoming
will also provide a constant water level for the skimmer.*
to you to adjust the system to better fit your aquarium.
IMPORTANT: The skimmer needs to run at least three to seven days before it starts foaming properly and the setting becomes final.
It is possible to notice some air bubbles entering the aquarium through the drainage. This is normal and these bubbles will disappear
once the skimmer reaches its operating balance.
*Rolf C Hagen Inc. assumes no liability for this type of installation in regards to water leaks, splashing or other unforeseen
mishaps as it is the full responsibility of the purchaser to ensure a safe and secure installation of this nature.
A B
C
Max.
Min.