Low Priority Errors - effegibi effe NUVOLA SMART POWER 110 Manuel De Montage

All manuals and user guides at all-guides.com
EN

5.4 LOW PRIORITY ERRORS

All the following errors belong to this type:
- Errors that allow for starting a new hammam
- Errors that interrupt an active hammam in a mono-generator system
- Errors that interrupt an active hammam in a multi-generator system only if they relate to all the generators in the
system
Example:
1) The water tap is closed or there is no water in the system thus the boiler does not reach the optimal pressure level.
2) The exhaust is not blocked so during the automatic rinsing or boiler emptying operation, the boiler does not empty
correctly.
In the event of a fault the user is required to:
1. Check that the water taps are open
2. Check that there is water in the system (by opening a tap that is part thereof )
3. Check that the electrical switches upstream of the system are correctly activated
4. In the event that the differential switch (circuit breaker) is activated, contact support prior to rearming the system
switch
5. Before contacting support, take note of the full description of the fault reported by the panel and of the Serial
Number
If these steps did not give a positive result, please contact the service centre or the company directly.
See the table on the following page for the analysis and the possible solution.
63 NUVOLA SMART POWER 110-140-180