Preliminary Warnings For Installation - effegibi effe NUVOLA SMART POWER 110 Manuel De Montage

EN
This manual is an integral part of the product and should be kept in a safe, accessible place.

2. PRELIMINARY WARNINGS FOR INSTALLATION

All connections must be performed by qualified personnel or an authorised service centre in compliance with local
regulations and international standards; CEI64.8 (IEC 60364 - 1). Electrical and hydraulic preinstallations must be
performed correctly, i.e.:
- the water line must be equipped with closing gate valve;
- the discharge line must be siphoned;
- the electric line must be equipped with adequate magnetothermal and differential switch as shown in the
wiring diagram;
The pipes must be connected in a reversible manner, i.e. allowing the removal of the steam generator e.g. for
extraordinary maintenance. The pipes must only consist of tubes made of brass or copper
- Install the steam generator in a dry and well ventilated area. Install it in internal areas to avoid freezing in
winter periods.
- Access to the steam generator must not be blocked for easier servicing.
1 Connection of panel devices - Provide an electrical sheath (ø 25mm) for the connection between the Generator and
the panel Identify the best point to place the control panel and/or other devices within the Turkish bath compartment,
considering a height of approximately 120 cm from the ground and avoiding the area above the steam diffusers; -
Insert the connecting cable into the sheath (supplied in 8m lengths); - Siliconize the rear part of the panel on the
whole circumference and apply it to the wall; - Perform the electrical connection to the generator in accordance with
the attached wiring diagrams, through connectors PAN1, PAN2.
2 Connecting the light fitting (optional) - Prepare an electrical sheath (ø 25 mm) for the connection between the
light fitting and the generator; - Perform the electrical connection to the generator in accordance with the attached
wiring diagrams, through connector BUS. - Use a jumper cable with characteristics suitable for the generator model
as per Table page 30.
3 Connection to the electrical network - (230 or 400 Volts 50 Hz) - Install an approved circuit breaker and protection
fuses on the electrical power supply line, upstream of the appliance, as specified in the attached wiring diagrams. The
minimum distance of the contacts must be 3 mm as indicated in the category for overvoltages III. - Provide a sheath
of suitable section. - Before connecting, carefully read the values on the identification label of the generator, placed
inside the cover and check that the supply voltage matches the voltage rating of the equipment. - First connect the
protection conductor (yellow - green) - In the event of maintenance remove the protective conductor last (yellow -
green).
If the power cable is damaged it must be replaced by the manufacturer, by its assistance service or by qualified
personnel to ensure any risks are avoided.
NUVOLA SMART POWER 110-140-180
All manuals and user guides at all-guides.com
10