Flashlight Function - GYS NOMAD POWER 20 Manuel D'utilisation

Translation of the original instructions

FLASHLIGHT FUNCTION

PROTECTIONS
This device is protected against short-circuits, overloads, deeply discharge and polarity inversions.
ANOMALIES, CAUSES, REMÈDES
TROUBLESHOOTING
No response while
pressing the ON/OFF
1
button
«Error» light ON on the
2
jumper cable.
«Error» light flashes red +
3
alarm beep.
The device is warm whilst
4
connected to a laptop.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
12
NOMAD POWER 20
Press the power button for 3 seconds to activate the LED.
Briefly press the button to switch lighting modes (4 available modes: normal,
flash, SOS and OFF).
CAUSES
The NOMAD POWER is dischar-
ged.
Internal battery voltage < 11.0V.
Polarity reversal
Short-circuit
Clamps have been left connected to
the battery.
-
Autogoods "130"
REMEDIES
Charge the product (see page 8).
Charge the product.
Check that the clamps are well connected and unplug/
plug back the jumper cable.
Check that the clamps are well connected and unplug/
plug back the jumper cable.
Remove the 2 clamps from the car battery in order to
protect the device.
Remove laptop's battery or unplug the NOMAD POWER
from the laptop for 5 minutes and plug it back again.
EN