GYS NOMAD POWER 20 Manuel D'utilisation page 11

Translation of the original instructions
OPERATION
Indicators
Lights
Internal battery
capacity for the
device
Indicators flash in turn, whilst charging the device. The number of indicators ON indicates the capacity of the NOMAD POWER internal
battery. All lights are steady if the battery is on hold or the charge is complete.
!
RECHARGE THE NOMAD POWER before first use and after each use.
INTERNAL BATTERY CHARGING
OR
STARTING THE VEHICLE
Emergency start function for petrol or diesel vehicles with a 12V battery.
To start a vehicle, please process as follows:
!
If the NOMAD POWER voltage is inferior to the vehicle voltage, the NOMAD POWER will not operate.
1
SMART
BOOSTER CABLE
Error
2
Start
3
10
NOMAD POWER 20
Press the power button
1 flashing 1 steady
0% 25%
1 - Connect mains adaptor to domestic mains.
2 - Connect the other end to the NOMAD POWER 14V/1A to start the charge.
1 - Connect car adaptor to the car cigarette lighter socket.
2 - Connect the other end to the NOMAD POWER 14V/1A to start the charge.
Connect the jumper cable to the NOMAD POWER connector.
If the lights «Start» and «Error» flash alternately in green and red, the product is ready.
If the red light only is ON, the internal battery voltage of the NOMAD POWER is too low.
In this event, charge your device.
Make sure the NOMAD POWER is charged by checking the number of indicators on the
device (minimum of 3 indicators ON (see page 8)).
to check internal battery level of the NOMAD POWER.
2 steady
50%
Autogoods "130"
3 steady 4 steady
75% 100%
EN