Maintenance / Cleaning; Declaration Of Conformity - Pentatech System 3000 Basic Instructions D'utilisation

#
Walls and floors, especially those containing metal, metalised foil,
reinforced concete or stone
#
Coated windows (eg. Energy saving windows), radiators, refridgerators,
mirrors, metalic surfaces or doors
#
Electrical wiring and electrical appliances (eg. motors, microwave
ovens)
#
Devices using the same or similar wireless frequency.
16. Troubleshooting
Fault Cause
short wireless range antenne is covered do not cover the front of the
of remote control
Alarm without PIR-detector reacts check positioning of PIR,
apparent reason to temperature
differences
PIR-detector does In operating mode Wait, or press the test
not react deactivated for up
to 5 minutes after
each detection
siren no longer reacts detector or remote
to detector or control is no longer components
remote control enrolled; e.g.
jumper position
has been changed
17. Maintenance + cleaning
#
Regularly check the technical safety and function
#
Before you clean the device, pull the mains adapter out of the mains
socket and remove the batteries.
#
Use a soft, dry or slightly moist cloth or a dry brush for cleaning the
surfaces.
18. Optional accessories
#
3000M, Door/window contact, Art.Nr.33531
#
3000R, Remote control, Art.Nr. 33532
#
3000P, PIR-detector, Art.Nr. 33530
#
3000 Set F4, GSM-wireless alarm system, Art.Nr. 33523
19. Enrolling further components to the siren
Use ear protection
!
Use a ball point pen to press the connect button (6) on the siren. The
siren beeps and the LED (3) lichts yellow/orange for 10 seconds. Within
this period you can enroll one of the following components:
#
Remote control: press the disarm button (12) once
#
PIR-detector: press the test button (23) twice
#
door/window contact: trigger by separating magnet from the sensor
The enrollment will be confirmed by the siren with a beep and LED (3)
will flash.
All manuals and user guides at all-guides.com
Remedy
remote control
do not point towards heat
sorces
button (23). After the
deactivation period the
unit will detect immediately
reset the siren and enroll all
20. Delete all components (Reset)
If a remote control is lost, delete all components and then enroll the
remaining components again (see chapter 19), to maintain the security of
the system.
!
To delete all remote controls and detectors hold the connect button (6)
on the siren with a ball point pen pressed until the deletion is confirmed
by a beep and flash.
Tip:
Enroll a remote control as the first item, by pressing the disarm button (12)
2 times, then you can cancel an unwanted alarm.
21. Disposal
Packaging material, used batteries or electrical products must not be
disposed of as household waste. Use your recycling system. Details
are available from your local authority.

22. Declaration of conformity

INDEXA GmbH, Paul-Böhringer-Str. 3, D - 74229 Oedheim, hereby declares
that the 3000 Set F3 is in compliance with the essential requirements and
other relevant provisions of Directive 1995/5/EC. The original of the
conformity assessment can be found on the web site www.pentatech.de.
23. Warranty
In addition to the statutory guarantee from the vendor, the manufacturer
warrants this product for 2 years from date of purchase (proof from receipt)
according to following conditions.This warranty does not affect your legal
rights. The warranty covers use of the product in normal conditions in private
households. It only covers manufacturing defects and is limited to the
replacement or repair of the faulty components. It does not include wear and
tear, or batteries. The warranty applies only when the product is used
according to the operating instructions. It does not cover damage arising
from misuse, improper handling, application of force, dust, dirt, water or
other environmental factors, or from incorrect voltage from batteries or power
supply.
The warranty is void when the product has been repaired or tampered by
unauthorised persons and when it has been used with components which are
not specified by the manufacturer. In case of a warranty claim please contact
the vendor for details of how to proceed and how to return the product if
necessary. Only carriage paid authorised returns will be accepted. Repairs
can only be accepted when accompanied by a full description of the fault.
After the warranty period has expired repairs will be charged and are not
always possible. Warranty claims do not extend the warranty period and the
warranty for replacement parts expires with the warranty for the product.
Unless there is a statutory obligation, the manufacturer is not responsible for
further claims, including peronal or material damages, arising from the use
of the product or from nonfunction or misfunction of the product.
31