Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Checking Flame Characteristics
Yellow Flames:
Further adjustment is
required.
Yellow Tips on Outer
Cones:
Normal for LP Gas
Soft Blue Flames:
Normal for Natural Gas
Conversion to LP Gas
The components required for this are contained in the
conversion kit included with this appliance, or are
available from Customer Service.
Important: After finishing, attach the sticker indicating
the new gas type close to the rating label if you change
to LP Gas, or remove the sticker if you are changing
back to Natural Gas.
Converting the Pressure Regulator
Locate the pressure regulator on the bottom right end of
the cooktop.
Note: The arrow on the back of the regulator must point
in the direction of the gas flow to the cooktop.
Remove the hexagon shaped cap from the regulator
1.
making sure not to dislodge the gasket on the cap or
the spring inside the regulator.
Note: If the flame is completely or mostly yellow, verify
that the regulator is set for the correct fuel. After
adjustment, retest.
Some yellow streaking is normal during the initial start-
up. Allow unit to operate 4-5 minutes and re-evaluate
before making adjustments.
Grasp the plastic button stem firmly and pull it
2.
forcefully from the metal cap. The stem snaps snugly
into an indent in the cap and may require a strong pull
to remove. (Hint: it may be helpful to gently "rock" the
plastic stem while pulling it from the metal cap.)
Spring
A
Plastic button stem
B
Gasket
C
After removing the stem from the cap, rotate the stem
3.
180° so the button end of the stem is away from the
cap and the letters "LP" on the stem are upside down
when the cap is set flat on its head. Snap the stem
back in place in this position inserting it into the indent
in the metal cap.The stem should snap into place.
11
Publicité
Chapitres
Table des Matières
