Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Display
"†
+ heat setting and
acoustic signal
and acoustic signal
"†
"‰
—...‹‹
š"
Do not place hot pans on the control panel.
Notes
If an error message with
▯
the display, the sensor for the element in question
must be held down in order to be able to read off the
fault code.
Disconnect the cooktop from the power supply, wait
▯
30 seconds, and then reconnect it again. If the display
appears again, contact technical Customer Service
and tell them the precise fault code.
Notes
The cooktop regulates the heating element
▯
temperature by turning the heat source on and off; this
means that the reddish glow of the heat source
beneath the heating element may not always be
visible. If you select a low heat setting, the heat source
is frequently off; at higher settings it is seldom off. The
source turns on and off even at the highest settings.
You may hear a quiet hum when the heating elements
▯
are in the heating phase. The heating elements may
glow with different levels of brightness. Depending on
the angle from which you are looking at the heating
element, this glow may be visible over the marked
edge of the heating element. These are technical
characteristics. They have no effect on quality and
function.
Glass ceramic may have uneven areas on the surface
▯
due to the nature of the material itself. Because of the
mirror-like finish on the cooking surface, even
extremely small bubbles less than 1 mm in diameter
may be visible. These bubbles will not have any
adverse effect on the operation of the cooktop nor on
the durability of the glass ceramic cooking surface.
Depending on the countertop that is present in the
▯
kitchen, an uneven gap between the cooktop unit and
the countertop can occur. For this reason, a flexible
seal is provided around the entire cooktop unit.
Possible cause
There is a hot pan in the area of the
control panel. There is a risk that the
electronics will overheat.
There is a hot pan in the area of the
control panel. To protect the electron-
ics, the element has been switched
off.
The element was operating for an
extended period without interruption.
The supply voltage is errory; outside
of the normal operating range.
The demo mode is activated
"
(e.g. E0111) appears on
Solution
Remove the pan. The error display goes out shortly
afterwards. You can continue to cook.
Remove the pan. Wait for a few seconds. Touch
any control. If the error display goes out, you can
continue to cook.
The automatic safety switch-off function has been
activated. See section "Automatic time limitation"
Contact your electricity provider.
Disconnect the cooktop from the power supply.
Wait 30 seconds and reconnect it. Touch any touch
control in the next three minutes. The demo mode
is deactivated.
How to Obtain Warranty Service
To obtain warranty service for your Product, you should
contact the nearest Bosch authorized servicer.
E number and FD number:
When you contact Service, please have the Model
(E) number and the FD number for your appliance
available. You can find the identification plate with these
numbers on the underside of the appliance and in the
appliance booklet. To avoid having to search for a long
time when you need it, you can enter your appliance data
and the customer support telephone number here.
E-Nr.
Customer Service
O
Questions? Please contact us. We look forward to
hearing from you!
FD-Nr.
19
Publicité
Table des Matières
