Before You Begin
Tools and Parts Needed
Phillips Head Screwdriver
▯
Precision Flathead Screwdriver
▯
Tape Measure
▯
Teflon Tape (Gas Rated)
▯
Adjustable Wrench or Channel Lock Pliers
▯
Parts Included
Cooktop
▯
Mounting Brackets (6)
▯
Sheet Metal Screws, DIN7982 4.2x25 (1") (6)
▯
Burner Grates (3)
▯
Burners (5)
▯
Burner Caps (6)
▯
OptiSim
Cap (1)
®
▯
Pressure Regulator
▯
LP Gas Conversion Kit
▯
Note: If parts are missing or damaged, call Customer
Support or write to the address listed on the inside back
cover.
Appliance Dimensions
General Requirements
The cabinet in which the cooktop is installed must be
▯
properly secured and stable.
The cabinets next to the cooktop, the laminated
▯
covering and glue for adhering it must be made of
non-flammable and heat resistant materials.
This appliance cannot be installed above fridges,
▯
washing machines, dishwashers or similar.
If an oven is installed underneath the cooktop, the
▯
thickness specified for the countertop surface may
exceed the minimum thickness stated in these
instructions. Observe the information in the oven
installation instructions.
6
Electrical Requirements
CAUTION
9
Do not use an extension cord with the gas cooktop.
This appliance requires a 60 Hz, 15 Amp, 120 VAC
connection. Plan the installation so that the power
connection is accessible from the front of the cabinet.
Gas Requirements
The cooktop is shipped from the factory for use with
natural gas. For use with LP conversion, a certified
technician or installer must do the conversion.
Supply Pressure:
Natural Gas: 7 inches water column (17.4 Millibars)
▯
Propane Gas: 11 inches water column (27.4 Millibars)
▯
The propane gas tank must be equipped with its own
high pressure regulator in addition to the pressure
regulator supplied with this unit.
Cabinet Requirements
Instructions are based on standard American cabinets
36" high (91 cm) x 24" deep (61 cm) with a 25" (63 cm)
countertop.
The maximum depth of a cabinet installed above the
cooktop is 13" (33 cm).
Note: All measurements given must be precisely
followed. If nonstandard cabinets are used, make sure
they are installed with minimum dimensions shown.
Plan the installation of the unit so that the power cord,
gas shut-off valve and gas pressure regulator are
accessible from the front of the cabinet.
For installation in a kitchen island, the minimum distance
from the cooktop to the edge of the countertop must be
at least 4" (100 mm).