Conversion To Lp Gas; Converting The Pressure Regulator - Bosch NGM8058UC Instructions D'installation

en-us Conversion to LP gas
Flame Image
Completely or mostly
yellow
Yellow tips on outer
cone
Soft blue

Conversion to LP gas

5 Conversion to LP gas
Your appliance is equipped for use with natural gas on de-
Conversion to LP gas
livery. It can be converted to LP gas supply.
The components required for conversion to LP gas are
contained in the LP conversion kit included with this appli-
ance, or are available from Customer Service.
→ "Customer Service", Page 17
Only a qualified technician or installer is authorized to con-
vert the appliance to another gas type.
Before carrying out the conversion, turn off the electricity
and gas supply.
5.1 Converting the pressure regulator
WARNING
Turn off the electricity and gas supply before carrying out
the conversion.
Requirement: Complete the installation instructions in this
manual up to and including section
→ "Securing the cooktop to the countertop", Page 10 be-
fore starting the LP conversion.
Locate the pressure regulator on the bottom right end of
1.
the appliance.
14
Measure
Verify that the regulator is set for the correct fuel. Retest af-
ter adjustment.
Normal for LP gas
Normal for natural gas
Remove the hexagon shaped conversion cap from the
2.
regulator. Make sure not to dislodge the gasket
the cap or the spring
Grasp the plastic orifice stem
3.
fully from the conversion cap
into an indent in the cap and may require a strong pull
to remove. It may be helpful to gently "rock" the plastic
stem while pulling it from the metal cap.
Rotate the stem 180°
4.
a Confirm that the button end of the orifice stem is away
from the conversion cap.
a Confirm that the letters "LP" on the orifice stem are up-
side down when the conversion cap is set flat on its
head.
inside the regulator.
firmly and pull it force-
. The stem snaps snugly
⁠ .
on