Abus TVVR33004 Notice D'utilisation page 77

Quickstart guide
Quickstart guide
Before you start
The following preparations must be completed:
1. Pay attention to the general information, safety
information as well as statements on placement and
connection.
2. Check the contents of the package for completeness
and damage.
Note
Note the remarks in the separate quickstart guide.
Connections at the back of the device
Note
Refer to the overview on page 75.
No Name
Function
1
VIDEO IN:
BNC input for HD-TVI and analogue cameras
2
HDMI
HDMI monitor connection
3
VGA:
VGA monitor connection (9-pin), video output
signal
4 USB:
USB connections for operating with a mouse and
data export
5 POWER SUPPLY
12 V DC
6 LAN:
Ethernet LAN connection
Installing the hard disk drive
Warning
Switch the device off and disconnect it from the
mains electricity.
Ensure proper earthing to avoid static discharge.
1. Install a hard disk drive, see separate quickstart
guide.
2. First make a connection to the motherboard with the
blue data cable (small connector).
3. Connect the power cable (large connector, 5-core).
4. Check that the connections are firmly in place.
5. Close the housing.
Note
Only use hard disk drives that are authorised for
video recording and 24/7 operation.
77
All manuals and user guides at all-guides.com
Make the connections
1.
2.
3.
4.
5.
Starting the device
When the device is connected to the power supply, it
starts up automatically and the LED status bar glows.
1.
2.
Configuring the device


Note
Observe the minimum radius when laying the
cables. Do not kink the cables.
Connect all cameras to the recorder.
Connect the recorder to the LAN via the network
cable.
Connect the monitor using the VGA or HDMI
connection.
Connect the mouse to the USB port.
Connect the device to the mains power supply, it will
then start automatically. The video surveillance sets
also include a distributor cable which enables
multiple cameras and the recorder to be operated
using a single power supply unit.
Note
During installation of the video surveillance sets,
ensure that the maximum power supplied by the
power supply unit will be sufficient for all the
devices connected. Please refer to the devices'
technical data for information about the maximum
power supplied.
If the power supply unit does not provide enough
power, please use suitable power supply units that
will supply enough voltage to the cameras.
Attention
The device may only be connected to a mains
voltage supply as specified on the type plate.
For security purposes, use an uninterruptible
power supply (UPS).
During the start-up procedure, the device carries out
a self-test.
Finally, the setup wizard appears. End this, to go to
live view.
Note
Note the remarks in the separate quickstart guide.
Carry out the individual steps in the "set-up wizard".
The following settings are configured one after the
other: (Sequence)
1. Select the operator console language
2. Administrator configuration