SSS Siedle plug+play BTSV 850-03 Mode D'emploi page 6

English
Mounting
Standard bus telephone with
colour monitor for
Siedle in-home bus
Functions:
• Calling, speech, vision, door
release and storey call
• Colour monitor 3.5" (8.8 cm)
• Door opener and light button
• Mute button for call tone
• 11 call tone melodies
• Monitor button for current picture
• Brightness and colour regulation
Electrical voltage
Mounting, installation and
servicing work on electrical
devices may only be performed
by a suitably qualified electrician.
Electrostatic charging
As a result of electrostatic charging,
direct contact with the circuit board
can result in destruction of the
device. Direct contact with the circuit
board must therefore be avoided.
Scope of supply
• BTSV 850-... (base plate and
housing with monitor unit)
• Receiver
• piral cable
• Operating instructions for the
end user
• This product information
Mounting
Strip back cable to appr. 80 mm.
1 Open the device from the back by
pressing in the locking lever.
2 Recommended mounting height
appr. 1.50 m /4.9 ft. to centre
device.
3 When mounting directly on the
wall, fasten the base plate using
4 screws, paying attention that the
plate is the right way up
(top marking).
4 When mounting on a switch box,
use the screw openings in the centre
4
of the device, paying attention that
the plate is the right way up (top
marking).
5 Install in accordance with the
wiring diagram. The cores of the
installation cable must be stored
inside the free installation space in
the base plate.
6 Insert the coloured plug of the
spiral cable into the socket at the
housing. A distinct click is audible
when the plug is correctly inserted.
7 Insert the other end of the spiral
cable in the receiver until the plug
clicks audibly into place. This con-
nection can no longer be detached.
8 With plug+play programming
do not close the housing until pro-
gramming is under way. Hook the
housing into the base plate from
above and close by exerting a slight
pressure.
Dismantling
9 To remove the housing, press the
lock upwards using a flat blade
screwdriver. The circuit board and
receiver remain on the upper part of
the housing.
Terminal assignment
TaM/TbM = In-home bus input
TaM/TbM = In-home bus throughput
ERT/ETb = Storey call button
+M/-M = additional supply
20–30 V DC
S1/S1 = potential-free contact
for extra doorbell
15 V AC, 30 V DC, 1 A
Commissioning
Installation and commissioning pro-
cedures are described in the system
manual (enclosed with Bus Video
Line Rectifier BVNG 650-...).
Accessories for BFCV 850-...
ZTCV 850-... table-top accessory for
conversion from a wall-mounted to
a table-top device.
Care of your phone
Only ever clean your telephone using
a soft cloth dampened with mild
soap solution. Dry cleaning,
aggressive cleaning agents and
abrasives can damage the surface.
Detailed care instructions are located
in the download area of
www.siedle.de
Servicing
Statutory warranty conditions apply.
Technical data
• Dimensions (mm) W x H x D:
105 x 277 x 45
• Operating voltage via in-home bus
• Operating current on supply via
+M/-M max. 300 mA
• Display 3,5" (8,8cm)
• Contact type Potential-free S1/S1
max. 15 V AC, 30V DC, 1A
Switching time 0.4 secs. - 19 mins.
• Call volume max. 83 dB (A)