Makita DSL800 Manuel D'instructions page 9

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
P aper siz e
P ad d iameter
R ated speed ( n)
D imensions
R ated v oltage
Net w eigh t
Due to our continuing program of research and development, the specifications herein are subject to change
w it h out noti c e.
Specifications may differ from country to country.
The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure
Applicable battery cartridge and charger
Battery cartridge
C h arger
Some of the battery cartridges and chargers listed above may not be available depending on your region of
resi d en c e.
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
WARNING:
and chargers may cause injury and/or fire.
Intended use
The tool is intended for sanding drywall or ceiling.
Noise
The typical A-weighted noise level determined accord-
ing to EN - - :
S oun d pressure le v el ( L
pA
Uncertainty (K) : dB(A)
The noise level under working may exceed
NOTE: The declared noise emission value(s) has been
measure d in a c c or d an c e w it h a stan d ar d test met h o d
and may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may
also be used in a preliminary assessment of exposure.
WARNING:
W ear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
) : dB(A)
dB (A).
1 ,000 - 1 ,8 00 min
1 ,1 00 mm - 1 ,5 20 mm x 25 9 mm x 273 mm
/ , are shown in the table.
BL N / BL / BL
BL B / BL
DC RC / DC RD / DC
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN
Work mode: disc sanding
Vibration emission (a
Uncertainty (K) : . m/s
NOTE: The declared vibration total value(s) has been
measure d in a c c or d an c e w it h a stan d ar d test met h o d
and may be used for comparing one tool with another.
NOTE: The declared vibration total value(s) may also
be used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual
use of the power tool can differ from the declared val-
ue(s) depending on the ways in which the tool is used
especially what kind of workpiece is processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
EC Declaration of Conformity
For European countries only
The EC declaration of conformity is included as Annex A
to t h is instru c tion manual.
9 ENGLISH
DSL800
225 mm
21 0 mm
-1
D .C . 1 8 V
4 .5 - 5 .7 kg
B / BL / BL B / BL
/ BL B / BL B
RE / DC SD / DC SE / DC
- - :
) : . m/s
2
or less
h , D S
2
/
SF