hestan KEC Serie Manuel page 14

CONTROLS AND SETTINGS
USING A DUAL ELEMENT ZONE
The 30" cooktop has a dual element zone (see page 7).
EN
To use the smaller part of the zone (inner element) , touch the selector key and set a power level.
To use the entire zone, touch the DOUBLE key. The DOUBLE indicator will illuminate when both
(inner and outer) elements are selected.
USING A TRIPLE ELEMENT ZONE
The 30" and 36" cooktops have a triple element zone (see page 7).
To use the smallest part of the zone (inner element) , touch the selector key and set a power level.
To use the inner and middle elements, touch the TRIPLE key. One of the TRIPLE indicators will
illuminate when the inner and middle elements are selected.
To use the third element as well (entire zone), touch the TRIPLE key again. Two TRIPLE indicators
will illuminate when the entire zone (inner, middle, and outer) elements are selected.
USING BRIDGE MODE
The 36" cooktop can use the two left cooking zones and a special element between them all
together in "Bridge Mode".
1. Touch the selection key for either of the left two zones.
2. Touch the BRIDGE key.
3. Set power using the slider for either of the bridged zones.
• Both of the left cooking zones and the bridge element are controlled together while bridged.
• Either zone's selector key will turn the entire bridged zone OFF.
EXITING BRIDGE MODE
To stop "Bridge Mode", use either zone's selector key to turn the zones off. This will stop "Bridge
Mode".
ZONE ACTIVE / HOT SURFACE INDICATORS
Each zone has a "Hot Surface" indicator light to show that the zone's surface is hot.
When a zone is activated, the light turns on, and it remains until the zone is deactivated and the
surface has cooled to a "safe to touch" temperature (approximately 150˚F).
RAPID BOIL FUNCTION
This function sets a zone to heat at full power (power level 9) for ten minutes, then it drops to the
set power. It is available for any zones, including bridged or double/triple zones.
To enable Rapid Boil: Select a zone and touch RAPID BOIL. You can set power before or after
selecting Rapid Boil.
The power indicator for the slected zone will alternate between "P" and the set power level.
KEY LOCK FUNCTION
The LOCK function disables all control functions except "Select/Zone OFF" and ON/OFF (all off).
To lock/unlock, touch the LOCK key for two seconds. The indicator light is ON when the controls
are locked.
12
©2018 Hestan Commercial Corporation
All manuals and user guides at all-guides.com
(CONTINUED)