Switching The Control On - hestan KEC Serie Manuel

Masquer les pouces Voir aussi pour KEC Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CONTROLS AND SETTINGS

SWITCHING THE CONTROL ON

If the commands are locked, touch the [LOCK] key for a few seconds. (See that the LOCK led is on
and turns off after a few seconds.)
Touch the main [ON/OFF] key to enable the single zones for
selection.
All the displays show power level "0". If you don't touch anything
else, the control shuts down again after about 10 seconds.
SELECTING AND SETTING ZONE POWER
Touch the ON key for the desired zone: the HOT SURFACE (ref.3)
indication starts flashing, waiting for user input.
Touch the slide bar to set the power level (levels 0 to 9). You can
slide your finger along the bar to select the desired value.
The display (ref.4) and the "Peacock Tail" (ref.6) shows the power
level, updated in real time.
After a 5 seconds time-out the value is accepted and the
HOT SURFACE led stops flashing.
The "Peacock Tail" disappears after some seconds more.
The following picture represents the Full Power Scale
where the control uses all the available power range from
0% up to the 100% corresponding to level 9.
Level 4 corresponds to 15% of the available power.
USING SIMMER
SIMMER is a low temperature mode, where a level of 9
in SIMMER has the same power as a level of 4 in normal
mode, 15% of full power.
Select a cooking zone, then touch the SIMMER key(ref.
8) to enable simmer mode, then set power with the slider.
In SIMMER mode, the inner numbers of the power scale
show selected power.
RETURNING TO NORMAL MODE
Select the zone and touch the SIMMER key again to
treturn to normal mode.
NOTE: The numeric power value stays the same, so
the power will increase to the normal amount for that
power level..
When a zone is turned off, the SIMMER mode is
halted for that zone as well.
TURNING A ZONE OFF
Touch the zone's OFF key to turn an active zone off.
To turn all zones off, touch the main ON/OFF key.
All manuals and user guides at all-guides.com
(CONTINUED)
6
2
3
Figure 7.
6
7
Figure 8.
9
8
Figure 9.
©2018 Hestan Commercial Corporation
EN
5
4
1
11

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Kec 30

Table des Matières