Replacing The Oven Lamp - Brandt BXE5532 Instructions D'utilisation

ENGLISH
DELAYED PYROLYSIS
Follow the instructions described in the «immediate
pyrolysis» and refer to Chapter 4.4 to adjust the
pyrolysis end time.
After these steps have been completed, the start of
pyrolysis is delayed so that it finishes at the
programmed time. When the pyrolysis cycle has
finished, return the function selector to 0.
5.3
CLEANING THE INSIDE GLASS
To clean the inside glass, remove the door. Before
doing this, remove any excess grease with a soft
cloth and washing up liquid.
Warning
Do not use scouring cleaning products,
abrasive sponges or metal scrapers to clean
the oven's class door, which may scratch the
surface and lead to the glass breaking.
REMOVAL
Open the door fully and block it with the plastic
wedge provided in your appliance's plastic pouch.
Remove the first clipped glass panel:
Use a tool (screwdriver) to press the slots A in order
to unclip the glass panel.
Remove the glass panel.
Depending on the model, the door consists of two
additional glass panels, with a black rubber spacer
at each corner. If necessary, remove them to clean.
Do not soak the glass panels in water. Rinse with
clean water and dry off with a lint-free cloth.
RE-ASSEMBLING THE DOOR
After cleaning, reposition the four rubber stops with
the arrow upwards.
Reposition all of the glass panels.
Slip the last glass panel into the metal stops, then
clip it in with the shiny side facing outwards.
Remove the plastic wedge.
Your appliance is now ready for use again.
5.4

REPLACING THE OVEN LAMP

Bulb specification:
15 W, 220-240 V~, 300°C, E14 cap.
To unscrew the view port and the light, use a
rubber glove, which will make disassembly easier.
Warning:
Make sure the appliance is disconnected
from the power before replacing the lamp
in order to avoid the risk of electric
shock. Change the lamp only when the
appliance has cooled down.
6
6.1
MENU
+
Press again to scroll through the different set-
tings.
Activate or de-activate the different parameters
with + and -; see table below:
To exit the "MENU", press
Settings
You can adjust different
settings on your oven. To
do so:
Press until you get to
the "MENU" display to
access the settings mode.
AUTO: In cooking mode ,
the light inside the oven
automatically turns itself
off after 90 seconds.
ON: In cooking mode ,
the light is on all the time.
Activate/de-activate the
beeping sound of the
buttons
Activate/de-activate pre-
heating mode
Activate/de-activate
demonstration mode
again.