Setting The Clock; Changing The Clock; Keypad Locking - Brandt BXE5532 Instructions D'utilisation

2
2.1
CHOICE OF LOCATION AND FITTING
The diagrams show the dimensions of a cabinet
that will be able to hold your oven.
This appliance may be installed either under a
worktop (A) or in a column (B). If the cabinet is
open, its opening at the back must be 70 mm
maximum.
Install the oven in the furniture. To do this,
remove the rubber stops and pre-drill a 2-mm
diameter hole in the wall of the furniture to avoid
splitting the wood. Attach the oven with the two
screws. Re-position the rubber stops.
Tip
To be certain that you have properly in-
stalled your appliance, do not hesitate to
call on a household appliance specialist.
Caution
Before using your oven for the first time,
heat it to 200°C empty for around 1 hour.
Ensure that the room is sufficiently aired.
ELECTRICAL CONNECTION
Your oven must be connected with a (standard)
power cable with 3 conductors of 1.5mm
1 neutral + earth) which must be connected to a
220-240V ~ single-phase grid by means of a 1 live
+ 1 neutral + earth CEI 60083 standard power
socket or via an all-poles cut-off device in compli-
ance with the installation rules.
The safety wire (green-yellow) is connected to the
appliance's terminal and must be connected to the
earth terminal of the electrical set-up.
The fuse in your set-up must be 16 amperes.
We cannot be held responsible for any accident resulting
from inexistent, defective or incorrect earthing.
Warning :
If the electrical installation in your residence
requires any changes in order to hook up
your appliance, contact a professional elec-
trician.If the oven malfunctions in any way,
unplug the appliance or remove the fuse cor-
responding to the sector where the oven is
.
hooked up
3
Installation
3.1
When switching on the display flashes at 12:00.
Set the clock with + or -.
Confirm with
If there is a power cut, the clock flashes.
3.2
The function selector switch must be in the 0
position.
Press
adjust the clock setting with + or - .
Confirm with
The cooking end time is automatically saved after
a few seconds.
3.3
This function can only be used when the
oven is off.
Press
The timer flashes.
Set the timer with + or -.
Press
Once the time has lapsed, there is a sound
signal. To stop it, press any key.
(1 live +
2
The time appears again in the display.
NB: You can modify or cancel the timer at any
time. To cancel, go back to the timer menu and
set to 00:00. Without having to confirm, the
adjustment is automatically saved after a few
seconds.
3.4
Press + and - at the same time until the
symbol appears on the screen. To unlock the
keypad, press + and - together until the
symbol disappears off the screen.

Setting the clock

SETTING THE CLOCK
.

CHANGING THE CLOCK

. The symbol appears. Press
.
TIMER
.
to confirm. The timer will then start.

KEYPAD LOCKING

ENGLISH
again,