Replacing The Oven Lamp - Brandt BXE5532X Guide D'utilisation

Table des Matières

Les langues disponibles

+ and - .

The cooking end time is automatically saved after a

few seconds. The cooking end time display stops

flashing.

CLEANING THE OUTER SURFACES

Use a window washing product applied to a soft

cloth. Do not use abrasive creams or scouring

sponges.

CLEANING INSIDE THE OVEN

Clean the still-warm oven with a cloth dipped in hot,

soapy water and wipe with a lint-free cloth.

5.1

REMOVING THE SHELF SUPPORTS AND

REPLACING THE CATALYTIC SIDE PANELS

Side panels with wire shelf supports :

Lift the front part of the wire shelf support

upwards. Press the entire shelf support and

release the front hook from its housing. Then

gently pull the whole of the support towards you

to release the rear hooks from their housing.

Remove the two shelf supports and the catalytic

side panels. Re-install the new elements

(side panels) following the procedure in

reverse.

5.2

CLEANING THE INSIDE GLASS

To clean the inside glass, remove the door. Before

doing this, remove any excess grease with a soft

cloth and washing up liquid.

Warning

Do not use scouring cleaning products,

abrasive sponges or metal scrapers to clean

the oven's class door, which may scratch the

surface and lead to the glass breaking.

REMOVAL

Open the door fully and block it with the plastic

wedge provided in your appliance's plastic pouch.

Remove the first clipped glass panel:

Use a tool (screwdriver) to press the slots A in order

to unclip the glass panel.

Remove the glass panel.

Depending on the model, the door consists of two

additional glass panels, with a black rubber spacer

at each corner. If necessary, remove them to clean.

Do not soak the glass panels in water. Rinse with

clean water and dry off with a lint-free cloth.

RE-ASSEMBLING THE DOOR

After cleaning, reposition the four rubber stops with

Cleaning

the arrow upwards.

Reposition all of the glass panels.

Slip the last glass panel into the metal stops, then

clip it in with the shiny side facing outwards.

Remove the plastic wedge.

Your appliance is now ready for use again.

5.3

Warning:

Make sure the appliance is disconnected

from the power before replacing the lamp

in order to avoid the risk of electric

shock. Change the lamp only when the

appliance has cooled down.

Bulb specification:

15 W, 220-240 V~, 300°C, E14 cap.

To unscrew the view port and the light, use a

rubber glove, which will make disassembly easier.

6.1

Press

tings.

Activate or de-activate the different parameters

with + and -; see table below:

To exit the "MENU", press