Cleaning The Catalytic Oven; Changing The Catalytic Walls - Brandt FC641WW Guide D'utilisation

99638333_A_ML.qxp 16/01/2007
6 / CARING FOR AND CLEANING YOUR APPLIANCE

CHANGING THE CATALYTIC WALLS

•
Before commencing disassembly, allow the
appliance to cool down and check that the
cooking selector switch is in the 0 position.
Lateral walls (1)
Unhook the wire shelf support (2) at the front
by lifting it ( diagram A). Pull the shelf support
structure towards you, lifting it so as to un-
hook the rear attachment ( diagram B). Re-
move it from the 2 holes (3) in the catalytic
wall and from the oven cavity. Then remove
the catalytic wall (1). Replace the new ele-
ments (wall and/or shelf supports) by per-
forming the operation in reverse.
Back wall (4)
Before performing this operation, unplug
the oven.
Completely unscrew the screw (5) located
at the top of the back wall. Tilt the wall for-
wards in order to remove it from the oven
cavity. Position the new panel by reversing
these steps.
Plug in the oven again.
Warning
- The oven must be turned off when cleaning inside the cavity.
15:00 Page 63
63
B
A
2
5
4
1
3
EN