Before Operation; Adding/Checking Engine Oil; Fuel Cap; Fuel Cap Air Vent - Powermate PM0152000 Manuel De L'opérateur

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Adding / Checking Engine Oil

•

Place generator on a level surface.

•

Remove screws and then remove the outer casing cover.

•

Remove the crankcase dipstick.

•

Insert a funnel into the crankcase dipstick hole and carefully add the specified amount of

4-Cycle engine oil to empty reservoir until or oil reaches the outer edge of the oil fill hole

(crankcase dipstick hole).

•

Be sure to replace dipstick and securely tighten before attempting to start the engine.

•

To check oil, set generator on a level surface, wipe dipstick clean, then reinsert dipstick

without re-threading.

Recommended Oil: See Oil Recommendations on page 15.

Oil Capacity: 0.35L (11.8 oz)

Fuel Cap

Turn counterclockwise to remove the fuel cap.

Fuel Cap Air Vent

The fuel cap is equipped with an air vent to stop fuel from flowing to the carburetor. The Air

Vent must be in the "ON" position to allow fuel to flow so that the engine can run. Turn the

Air Vent to the "OFF" position to stop fuel flow.

Fuel

Fill the tank with clean, fresh unleaded automotive gasoline. Regular grade gasoline may be

used provided a high octane rating is obtained (at least 85 pump octane). We recommend

always using a fuel stabilizer. A fuel stabilizer will minimize the formulation of fuel gum

deposits during storage. The fuel stabilizer can be added to the gasoline in the fuel tank, or

into the gasoline in a storage container.

Adding Fuel

•

Set generator on a clean and level surface in an area that is well ventilated.

•

Do not smoke while adding fuel.

•

Remove fuel cap.

•

Insert a funnel into the fuel tank and carefully pour gasoline into the tank until fuel level reaches about 1 ½ inches below the

top of the neck. Be careful not to overfill the tank to provide space for fuel expansion.

•

Replace fuel cap and secure tightly.

English