Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Stopping the Engine
•
Turn the Engine Economy Switch to the "OFF" position.
•
Disconnect any electronic device. All loads MUST be disconnected from the generator.
Never start or stop the engine with electrical devices plugged in to the receptacles.
•
Turn the 3 in 1 Start Switch to the "OFF" position.
•
Turn the fuel cap Air Vent to the "OFF" position.
•
Never start or stop engine with electrical devices
plugged in to the receptacles. Failure to do so
could damage the generator and / or connected
electrical devices.
•
Always start the engine and let it stabilize before
connecting any electronic devices.
•
Disconnect all electronic devices before stopping
the engine.
Attaching Electronic Devices
1.
Before Starting generator
•
Make sure the generator is grounded (see page 9 for instructions).
•
Make sure the attached load is within the generator rated output and the receptacle's rated current.
•
Make sure all electrical cords and receptacles are in good condition.
•
Make sure all electronic devices are turned "OFF" before plugging them into the generator.
2. Start engine.
3.
If the attached load is small, turn the Engine Economy Switch to the "ON" position. For a larger load, or if attaching
multiple electronic devices, turn the Engine Economy Switch to the "OFF" position.
4.
Make sure the green AC power indicator light is on.
5. When engine has stabilized, plug in and turn on first load. It is strongly recommended to plug in devices with the largest
output first and the smallest output last to help prevent overloading the generator.
6.
Allow generator output to stabilize (engine and attached devices run evenly) before plugging in the next load.
English
OPERATION
OPERATION
13
Customer Hotline 1-800-445-1805
Publicité
Table des Matières
