Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Engine Long Term Storage
•
Remove the spark plug and pour about 1 teaspoon of 10W30 engine oil into the spark plug hole. Reinstall the spark plug.
With the 3 in 1 switch in the "OFF" position, pull the recoil starter cord several times to coat the cylinder walls with oil.
•
Slowly pull the recoil starter until you feel the engine build compression (when you feel resistance). Leave the engine in
this state as this will prevent any corrosion on the cylinder walls if stored for a long period of time.
Draining the Fuel
•
Turn the 3 in 1 switch to the "OFF" position.
•
Remove fuel cap and fuel tank filter.
•
Use a siphon to transfer gasoline from generator into a gasoline approved container.
•
Wipe up any spilled fuel with a clean rag.
•
Start generator engine and let it run until it stops and all remaining fuel is consumed. Do not connect electronic devices
to generator during this process.
•
Remove outer casing screws, then remove outer casing.
•
Drain fuel from carburetor by loosening the drain screw on the carburetor float chamber.
•
Turn the 3 in 1 switch to "OFF"
•
Tighten the drain screw.
•
Install the outer casing and tighten screws.
•
When the engine has completely cooled down, turn the Fuel Cap Air Vent to the "OFF" position.
English
MAINTENANCE
MAINTENANCE
Contact with a hot engine or exhaust system can
cause serious burns or fires. Let the engine cool
before transporting or storing the generator.
Do not drop or strike the generator when
transporting. Do not place heavy objects on the
generator.
19
Customer Hotline 1-800-445-1805
Publicité
Table des Matières
