Télécharger Imprimer la page

Bronpi HYDRONIAGARA Mode D'emploi page 7

Publicité

-Maximum température ambiante, 60 ° C
-Charge maximale de la chaîne; 100-800 gr.
Σύστηµα ρύθµισης καύσης
GR
Το σύστηµα διαθέτει µια βαλβίδα ρύθµισης η οποία έχει τα παρακάτω
χαρακτηριστικά:
- Αυτόµατο έλεγχο της εισαγωγής αέρα.
- Έλεγχος της έντασης της φλόγας µε βάση της ανάγκες του συστήµατος, µε
αποτέλεσµα την επίτευξη µιας ευχάριστης θερµοκρασίας δωµατίου µε ταυτόχρονη
µείωση της κατανάλωσης καυσίµου.
- Εύρος ρύθµισης: 30 – 90
- Μέγιστη θερµοκρασία νερού: 120
- Μέγιστη θερµοκρασία δωµατίου: 60
- Εύρος φορτίου αλυσίδας: 100 – 800 gr.
ESP
Instalación del regulador
Atornille el adaptador cónico de 3/4" en la parte superior en la adecuada
orientación, tendrá que estar fijado mirando hacia la trasera de la caldera.
Elimine el tubo de plástico utilizado para el transporte e introduzca en el
agujero la palanca con su cadena por el lado sin agujerear.
Apriete bien los tornillos de manera que la parte libre de la palanca se
encuentre por encima de la trampilla de entrada de aire primario y que la
palanca adquiera una posición lo más horizontal posible (todo lo que nos
permita el hexágono). Enganche la cadena en la ranura de la palanca con el
gancho grande que pende de la cadena. Pase la otra extremidad de la cadena
a través del punto de anclaje de la trampilla y fije el lado libre de la cadena.
Controle que la cadena y la palanca se puedan mover con libertad cuando se
gira la manopla.
La escala de referencia será la roja
ENG
Regulator installation
Screw the conical adapter of 3/4" on the top in the right position. It must be
placed towards the rear part of the boiler.
Remove the plastic tube used for the transport and insert into the hole the
lever with its chain on the side which is not perforated.
Tighten the screws so that the free part of the lever is above the trapdoor of
the primary air inlet and that lever is as horizontal as possible (all the hexagon
allows us). Connect the chain to the slot of the lever with large hook hanging
from the chain. Pass the other end of the chain through the anchor point of
the trapdoor and attach the free side of the chain. Check the chain and the
lever can move freely when you turn the knob.
The reference scale is the red one.
All manuals and user guides at all-guides.com
0
C.
0
C.
0
C

Publicité

loading