Technical Data - Martin Yale intimus 155 Instructions D'opération

GB
ASSEMBLY INSTRUCTIONS:
Assemble the unit as per the following instructions:
1. Unpack the shredder, the receptacle and the
stand.
2. Place the shredder upside down on a flat
surface and push both ends of the stand into
the openings in the housing as far as they will
go (as shown in fig. 1).
3. Turn the shredder and the stand over and set
the unit down with the stand on the floor.
4. Push the receptacle under the shredder as far
as it will go (fig. 2).
CLEANING THE PHOTOCELLS (fig. 5):
If paper particles should come to rest in the inlet
guide (for example after a paper jam) it is possible
that the machine will not turn off, due to the broken
light barrier.
To remove these paper strips and also to clean
the photocell, pass another sheet of paper through
the feed slot, or switch the machine to reverse and
wipe both „eyes" of the photocell with a brush.
If too much paper is fed to the cutting system the
machine will react as follows:
- The cutting system blocks and then stops.
- The motor shuts down automatically.
Proceed as follows:
- Turn the function switch (1) (fig. 1) briefly to
position „bowed arrow", then in position „0".
- Remove excess paper from the machine and
continue shredding with less paper.
MOTOR PROTECTION:
The motor shuts down automatically, should it
become overloaded. Turn the function switch in
position „0".
Allow the motor to cool down for 15 to 20 minutes
(depending upon room temperature) and then
continue shredding.
INSTALLATION
MAINTENANCE
MALFUNCTION
CHECKLIST IN CASE OF MALFUNCTIONS:
If the device does not function, check the following:
- is the plug connected to the mains?
- is the function switch (1) on?
- is the receptacle placed properly under the
machine?
- is the receptacle full?
The receptacle has to be emptied.
- is there a paper jam?
Follow the instructions under „paper jam".
- has the motor been overloaded?
Wait until the motor has cooled, and then restart.
If none of the above applies, please contact
your dealer.
Note: For orders of special accessories and spare
parts, please contact your dealer.
fig. 4
2
fig. 5
5
fig. 3
TIP FOR ENERGY SAVING:
Please make sure that the shredder is switched
off over night (function switch (1) (fig. 1).

TECHNICAL DATA

Cutting width:
155: 4 mm (strips)
155CC: 4x28 mm (cross-cut)
Cutting capacity:
155: 10-12 sheets (70g/m
155CC: 6-8 sheets (70g/m
Supply voltage: see name plate
Pre-fusing: 10 amps (slow-blow)
Working width: 230 mm
Noise level: approx. 54-56 dB(A)
Power: see name plate
Short-time operation: 8 min ON
15 min OFF
Dimensions:
Width: 350 mm
Depth: 250 mm
Height: 550 mm
Weight: approx. 9 kg
2
)
2 )