Midea COOLIX MSC2-12HRDN1-QE Instructions D'installation page 48

40
All manuals and user guides at all-guides.com
START-UP
The initial start-up of the appliance must be performed by the manufacturer or one of his authorised technicians.
All regulating, control, and safety devices must be checked for function and correct settings.
The start-up for the indoor unit must be performed and documented according to the operating instructions for the outdoor
unit!
function test foR the cool opeRating mode
Proceed as follows during start-up:
· Turn on the power supply.
· Use the remote control to turn on the indoor unit.
· Use the TEMP button to set the desired temperature lower than the existing room temperature.
· Use the MODE button to set the COOL mode. Complete cooling is not achieved until 3 to 5 minutes later.
· Check the appliance control for functions described in the "Operation" section.
· Timer, temperature setting, fan speeds, and switching between Fan and Dehumidify modes.
· Note that cooling must discontinue if the desired temperature is set above the room temperature. This process may take
about 1 minute.
· Measure all operating currents and check all safety functions.
· Check the function of the float switch, water tank, and water pump by pouring distilled water into the water tank.
· It is recommended to use a scoop bottle that can feed the water into the water tank.
· Please note that the water pump will permanently pump out accumulated water when the indoor appliance is working
in the Cool or Dehumidify mode.
function test foR the heat opeRating mode
Proceed as follows during start-up:
· Use the TEMP button to set the desired temperature higher than the existing room temperature.
· Press the MODE button to set the HEAT mode. Complete heat output is not achieved until 3 to 5 minutes later.
· Note that heating must discontinue if the desired temperature is set below the room temperature. This process may take
about 1 minute.
· Measure all operating currents and check all safety functions.