Midea COOLIX MSC2-12HRDN1-QE Instructions D'installation page 40

2. boRe in the Wall
· Determine the drilled holes according to the illustration.
· Bore a hole with a diameter of about 65 mm sloped toward the outside.
· Use pipe liner (plastic pipe) when drilling through metal screen or metal plates to shield the electric wiring.
· Hang the indoor unit onto the mounting plate to mark the drilling hole. Then mark the drilling hole on the lower left
of the indoor appliance.
· Remove the indoor appliance from the wall for drilling.
INSTALLATION OF THE CONDENSATION DRAINAGE HOSE
dRain
Bend the condensation drainage hose toward the bottom and always install the hose sloping down. Do NOT install the con-
densation drainage hose as shown in the illustration below.
Do not obstruct the water flow by bending the hose.
Do not create an incline!
All manuals and user guides at all-guides.com
Do not place the end of the hose
in water
Inside Outside
5-7 mm
Wall
33
EN