Removing And Inserting The Brew Group; Reinserting The Brew Group; Cleaning And Maintenance - Saeco GranAroma DELUXE SM6680/00 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 170
Before activating the AquaClean water filter, it has to be prepared by soaking it in water as described below.
If you don't do this, air might be drawn into the machine instead of water, which makes a lot of noise and
prevents the machine from being able to brew coffee.
1 Tap the 'Status' icon and scroll from left to right to select 'AquaClean'.
2 Tap the confirmation
screen.
Replacing the AquaClean water filter (5 min.)
After 95 liters of water have flowed through the filter, the filter will cease to work. The AquaClean status
indicator drops to 0% to remind you to replace the filter. If you do not replace the AquaClean water filter in
time, you can still replace the filter but you first need to descale the machine.
When the AquaClean status indicator drops to 0% or when the machine reminds you to replace the
AquaClean filter:
1 take out the old AquaClean water filter.
2 install a new filter and activate it as described in chapter 'Activating the AquaClean water filter (5 min.)'.
Replace the AquaClean water filter at least every 3 months, even if the machine does not yet indicate that
replacement is required.

Removing and inserting the brew group

Go to the 'Status' menu on the screen and select 'Brew group clean' or visit www.saeco.com/care for
detailed video instructions on how to remove, insert and clean the brew group.
Removing the brew group from the machine
1 Remove the water tank and open the service door (Fig. 13).
2 Press the PUSH handle (Fig. 14) and pull at the grip of the brew group to remove it from the machine
(Fig. 15).
When you remove the brew group from the machine, make sure to empty the drip tray and the coffee
grounds container.

Reinserting the brew group

Before you slide the brew group back into the machine, make sure it is in the correct position.
1 Check if the brew group is in the correct position. The arrow on the yellow cylinder on the side of the
brew group has to be aligned with the black arrow and N (Fig. 16).
-
If they are not aligned, push down the lever until it is in contact with the base of the brew group (Fig.
17).
2 Slide the brew group back into the machine along the guiding rails on the sides (Fig. 18) until it locks into
position with a click (Fig. 19). Do not press the PUSH button.
3 Close the service door and place back the water tank.

Cleaning and maintenance

Your machine will advise you when to perform cleaning and maintenance.
Regular cleaning and maintenance keeps your machine in top condition and ensures good-tasting coffee
for a long time with a steady coffee flow.
icon again when the activation screen appears. Follow the instructions on the
13
English

Publicité

Table des Matières
loading

Table des Matières