Cleaning The Brew Group - Saeco Talea Giro Mode D'emploi

CLEANING THE BREW GROUP

The Brew Group must be cleaned at least once a week. Before removing the Brew Group, remove the
dregs drawer as shown in fi g. 4 on page 18. Once you have washed and inserted the Brew Group, insert
the dregs drawer and close the service door.
1
Press the "PUSH" button to
remove the Brew Group.
4
Make sure the components are in
the correct position.
The hook shown must be in the
correct position; to check its
position, fi rmly press the "PUSH"
button.
7
Insert the dregs drawer and close
the service door.
2
Wash the Brew Group with
running water. Wash fi lters
carefully.
5
The lever on the rear part of the
group must be in contact with
the brew group base.
3
Make sure the Brew Group is in
rest position; the two references
must match.
6
Insert the washed and dried Brew
Group.
DO NOT PRESS THE "PUSH"
BUTTON.
19