STEINEL XLED PRO ONE S Mode D'emploi page 55

The light source of this light cannot be replaced. If the light
source needs to be replaced (e.g. at the end of its service
life), the complete light must be replaced.
5. Installation
Hazard from electrical power.
Touching live parts can result in electrical shock, burns or
death.
• Switch OFF power and interrupt power supply.
• Using a voltage tester, check to make sure that the
power supply is disconnected.
• Make sure power supply remains interrupted.
Risk of damage to property!
Mixing up connection leads may produce a short circuit.
• Identify connection leads.
• Connect the leads correctly.
Preparing for installation
• Check all components for damage. Do not use the
floodlight if it is damaged.
• Select an appropriate site to install the product.
– Take reach into consideration.
– Take reach and motion detection into consideration.
– Vibration-free.
– No obstacles in detection zone.
– Not in explosive atmospheres.
– Not on normally flammable surfaces.
– 14 –
Index