Keysight U1271A Guide De Démarrage Rapide page 14

Continuity tests
Set up your multimeter as shown in the figure
below to perform continuity tests. Press
switch to the continuity test function (
on the display).
You can set the beeper to sound and the
backlight to flash as a continuity indication
whether the circuit-under-test is less than (short)
or more than or equal to (open) the threshold
resistance.
Press
(
NC (normal close) contacts.
The continuity function detects intermittent shorts
NOTE
and opens lasting as short as 1 ms. A brief short or
open causes the multimeter to emit a short beep
and flash.
14
to switch between short (
Dual
E xit
) states for checking NO (normal open) and
Keysight U1271A/U1272A Quick Start Guide
is shown
) and open
OFF
( open)
ON
( closed)
to