Before Initial Use; Use - gourmetmaxx CM4313AM-GS Mode D'emploi

Before Initial Use

CAUTION!
■ Keep children and animals away from the packaging material. There is a danger of
suffocation!
1. Unpack the device and check the items supplied for completeness (see the "Items
Supplied and Device Overview" chapter) and transport damage. If you fi nd any dam-
age, do not use the device (!), but contact our customer service department.
2. Remove any fi lms and stickers that may be present from the device.
3. Before you fi rst use the device, we recommend that you let two to three full tanks
of water run through the coffee machine without any coffee powder in order to fl ush
through all the lines etc. and to rid them of any possible production residues. To do
this, follow the instructions in the "Use" chapter.
4. Then clean the permanent fi lter, the fi lter holder and the jug with hot water and a little
detergent. Dry these parts before they are placed back inside the device.

Use

CAUTION!
■ In the interest of your own safety, inspect the device for damage each time before
you use it. Only use it if the device, mains cable and plug have no signs of damage!
■ Danger of burns from steam escaping! Never open the water tank cover when the
device is switched on. Also do not pour any water into the water tank while the device
is hot! Hot steam or hot spray water may escape. Always switch off the device fi rst
and allow it to cool down before you add any more water.
■ Danger of burns! The storage plate, the fi lter and fi lter holder are hot during the
brewing process and immediately afterwards. There may also be hot water inside the
fi lter and fi lter holder. Let these parts cool down before you touch them.
■ Never switch on the device without water in the water tank! The pump may be dam-
aged.
■ Do not overfi ll the water tank in order to prevent the jug from overfl owing later on! Do
not exceed the MAX marking on the water level indicator.
■ Before you fi rst operate the device, make sure that the water tank cover is closed and
that the permanent fi lter and the fi lter holder are inserted correctly so that the water
can run through the coffee powder without any problems.
■ Do not operate the device unattended so that you can intervene immediately in the
event of any malfunctions (e.g. overfl ow etc.).
■ Clean the device regularly in the manner described in the "Care" chapter.
The device has overheating protection which prevents the device from being
switched on again directly after a brewing process for safety reasons. After a
brewing process, you should therefore wait for a few minutes until the device has
cooled down before you start another brewing process.
All manuals and user guides at all-guides.com
15 EN