3) Press the button to go to the setting
, i e the muting function is not
& Power
locked
4) After selection, use the button SET to go to the
line
Lock OFF
5) Press the button to activate the key lock
(ON)
6) Press the button SET to save the setting
When a button is pressed, the following message
appears:
Press Set
for 2 Sec.
to unlock
keypad.
When the switch MUTE (8) is used while
selected, the following message appears:
Lock ALL
Mute
function is
disabled.
Notes:
1 When the key lock is activated and the menu is
deactivated, the symbol
2 The key lock can also be activated or deactivated di-
rectly on the receivers UF-20R/5 and UF-20S/5 via
the REMOSET function (refer to the instruction manual
of the receivers)
– Deactivating the lock –
1) Keep the button SET pressed for two seconds
until the menu
KeyLock
ALL
Lock ON
2) Press the button SET once again so that
appears in the lower line
OFF
3) Press the button to select the setting
and press the button SET to save the setting
All rights reserved by MONACOR
reproduced in any form or by any means for any commercial use
18
All manuals and user guides at all-guides.com
The line indicates
ON/OFF
ALL
appears on the display
appears
KeyLock
Fig. 17
INTERNATIONAL GmbH & Co KG No part of this instruction manual may be
®
4 Specifications
Set
Carrier frequency range: 530 – 605 MHz
Frequency stability:
Transmission power (EIRP)
Low:
High:
REMOSET frequency:
Audio frequency range: 50 – 18 000 Hz
Low-cut filter:
Ambient temperature:
Power supply:
Operating time:
is
Dimensions :
Weight:
Microphone connection: 4-pole mini XLR jack
1
4
2
3
Fig. 18 Microphone jack
1 = ground
2 = 5 V operating voltage for the microphone
3 = signal input
4 = impedance correction
ON/
OFF
Subject to technical modification
±0 005 %
10 mW
50 mW
2 4 GHz
100 Hz, 18 dB/octave
0 – 40 °C
2 (rech ) batteries
of size AA
> 20 h with
3400 mAh rech bat-
teries
62 × 170 × 23 mm
90 g