Husqvarna Soff-Cut 150 Manuel D'utilisation page 19

3. Tighten the locking clamp wheel (B).
4. Pull and hold the release lever when you tilt the
product. Push the handlebar down to set the product
in tilt position.
5. Release the lever to lock the product at tilt position.
714 - 004 - 06.07.2021
B
6. Turn the 2 locking knobs counterclockwise and
remove the blade block cover.
A
7. Put one of the included wrenches in the slot at the
front of the engine. Put the other included wrench on
the blade shaft bolt.
8. Turn the blade shaft counterclockwise with the
wrench on the blade shaft bolt until the wrench in the
slot engages on the flat surfaces of the blade shaft.
9. Continue to turn the blade shaft bolt
counterclockwise to remove the blade shaft bolt.
10. Remove the outer blade flange.
11. Fully clean the concrete from the shaft, blade block
and blade block cover.
12. Install the cutting blade on the blade shaft. Make
sure that the cutting blade is tight around the shaft.
13. Install the outer blade flange. Tighten the bolt fully.
14. Model Soff-Cut 150: Install a new skid plate.
X 150
CAUTION: Do not install a used skid
plate.
X 150 D
19