1
2
1
2
BATT
CGR-D08A/1B
A
B
CGR-D16A/1B
A
B
A
CGP-D28A/1B
B
A
CGR-D53A/1K
B
12
Power Supply
ª Using the AC Adaptor
1
1
2
3
≥The AC Cable's outlet plug cannot be pushed fully into the AC Adaptor
Jack. A gap will remain as shown
≥Before disconnecting the power supply, set the [OFF/ON/MODE] Switch on
the Palmcorder to [OFF].
≥Battery cannot be charged if DC Cable is connected to AC Adapter.
3
ª Using the Battery
Before use, fully charge the battery.
1
2
Disconnecting the Power Source
Set the [OFF/ON/MODE] Switch
M
right
≥When attaching or removing battery, set [OFF/ON/MODE] Switch to
[OFF] and make sure the Operation Mode Lamp is not lit.
≥For other notes, see page 56.
Charging Time and Available Recording Time
A
1 h.
B
≥"1 h 20 min." indicates 1 hour and 20 minutes.
2 h 10 min.
≥Battery CGR-D08R is supplied.
(1 h 35 min.)
≥The hours shown in the table are approximate hours. The numeric
2 h.
characters in parentheses indicate the recording time when the LCD
monitor is used. In actual use, the available recording time may be shorter
4 h 20 min.
(3 h 10 min.)
in some cases.
≥The hours shown in the table are for continuous recording at a temperature
3 h 15 min.
of 68xF (20xC) and humidity of 60%. If the Battery is charged at a higher or
7 h 40 min.
lower temperature, the charging time may longer.
(5 h 35 min.)
5 h 20 min.
14 h 10 min.
(10 h 25 min.)
Insert the battery-shaped connector of the DC Cable into the
Battery Holder on the Palmcorder.
Connect the DC Cable to the [DC OUT] Jack on the AC
Adaptor.
Connect the AC Adaptor and AC Cable.
Attach the Battery to AC Adaptor and charge it.
≥Since the Battery will not be charged when the DC Cable is connected
to the AC Adaptor, disconnect it.
≥The [POWER] Lamp and [CHARGE] Lamp lights up, and charging
starts.
≥When the [CHARGE] Lamp goes off, charging is completed.
Attach the charged Battery to the Palmcorder.
2
, and then slide the Battery to remove it.
~~~~~~~~~~~~~~~~~~~~~~~~
Charging Time
Maximum Continuous Recording Time
1
.
1
to [OFF], and the [BATT] Lever to the