Air Source - PRO-POINT 8344129 Manuel D'utilisateur

V 3.0

air SoUrce

1. Disconnect air supply. Disconnect tools from air pressure
source when not in use, before cleaning, servicing or
changing a piece or accessory. After disconnecting,
discharge any residual air pressure.
2. Do not use tools if the trigger switch does not function
properly. Any tool that cannot be controlled with the
ON/OFF switch is dangerous and must be repaired.
3. Use proper size and type of air pressure line and fittings.
The recommended air line for a tool with a 1/4 in. inlet is
3/8 in. I.D.
4. Always verify prior to using a tool that the air source has
been adjusted to the rated air pressure or within the rated
air-pressure range. Over pressurizing a tool may cause
bursting, abnormal operation, breakage of the tool or serious
injury to persons. Use only clean, dry, regulated compressed
air at the rated range as marked on the tool.
5. Never use pure oxygen, carbon dioxide, combustible gases
or any bottled gas as an air source for a tool. Such gases
are capable of causing an explosion and serious injury to
persons. Do not use an air source besides an air compressor
to power this tool.
6. Always use an air regulator, an in-line filter and a moisture
trap in your compressed air system. These accessories will
increase the tool's life and keeps the tool in good working
condition. See the diagram above for recommended
components of an air line.
7. Drain the air tank daily. Water in the air line will damage
the tool.
8. Clean air inlet filter weekly.
9. Avoid using an unnecessarily long air hose. Choose a hose
that is appropriate for the situation, as a hose that is too
long and running across the floor can be more dangerous
than helpful.
10. Keep hose away from heat, oil and sharp edges. Check hose
for wear, and make certain that all connections are secure.
11. Always carry a tool by its handle, never carry the tool by the
air hose.
8
All manuals and user guides at all-guides.com
Reciprocating Air Saw
For technical questions call 1-800-665-8685
8344129