PRO-POINT 8344129 Manuel D'utilisateur page 10

V 3.0
1. All air tools are packed in grease to prevent corrosion of
internal parts during shipping and storage. We recommend
you clean this out to have optimum performance from your
new air tool. Add a generous amount of air tool oil in the air
inlet, then run the tool under no load until exhaust is clear to
remove packing grease. For future maintenance, add only
one or two drops of oil daily.
2. It is important that the tool be properly lubricated by
keeping the air line lubricator filled and correctly adjusted.
Without proper lubrication the tool will not work properly
and parts will wear prematurely.
3. Use the proper lubricant in the air line lubricator. The
lubricator should be of low air flow or changing air flow
type, and should be kept filled to the correct level. Use only
recommended lubricants, specially made for pneumatic
applications. Substitutes may harm the rubber compounds in
the tools O-rings and other rubber parts.
iMportant! if a filter/regulator/lubricator is not installed on the
air system, air operated tools should be lubricated at least once
a day or after 2 hours work with 2 to 6 drops of oil, depending
on the work environment, directly through the male fitting in the
tool housing.
WarninG! neVer use Wd-40 to clean or lubricate your air tool.
Wd-40 is a solvent that will break down the internal grease and
cause the air tool to seize up.
10
All manuals and user guides at all-guides.com
Reciprocating Air Saw
For technical questions call 1-800-665-8685
8344129